Edge Comp Dodge Cummins Performance Chip
- Made in the USA
- Has 5 power levels
- Gains 40-120 horsepower
- Not legal to use while driving on the street in California
- Monitors RPM, timing, turbo boost pressure and fueling parameters
- Controls fueling and timing improvements for the Bosch fuel injection pump
The Edge Comp Dodge Cummins performance chip monitors the RPM, timing, turbo boost pressure and fueling parameters. This item can only be used on a Dodge Cummins. With the information that this item monitors, it is able to control the fueling and timing improvements for the Bosch fuel injection pump. You can control the timing and fueling improvements by connecting into the Bosch fuel injection pump or being controlled by the CAN-BUS through the Data Link.
The Edge Comp Dodge Cummins performance chip has power gains of 40-120 horsepower by having five different power levels. With five adjustable sub-levels for each level, this helps to control low boost fueling. It also has responsiveness settings so you are able to set up the responsiveness and low boost smoke control. Additionally, this is easy to install and mounts inside your cab.
Below are the horsepower and torque you get with each level:
Level 1: 40 HP - 150 LB/FT of Torque
Level 2: 60 HP - 200 LB/FT of Torque
Level 3: 80 HP - 250 LB/FT of Torque
Level 4: 100 HP - 300 LB/FT of Torque
Level 5: 120 HP - 350 LB/FT of Torque
Frequently Asked Questions
Here are some answers to frequently asked questions about the Comp module. For additional information, please call 1-877-216-5446 or 701-253-5906
DODGE COMP FAQ’s
Q: WILL INSTALLING THE DODGE COMP VOID MY FACTORY WARRANTY? A: While the answer is straightforward from a legal standpoint, we also want to educate our customers (and after-market consumers) on some industry realities and offer some common sense precautions to minimize your risk. Consumers of aftermarket products are protected by The Federal Magnusson-Moss Warranty Act. The Act states that if something breaks on your car and you take it in for warranty repair, the dealer must honor your warranty unless they can prove that whatever modifications you have added to your car actually caused the problem. While as a consumer you have strong legal protection regarding your vehicle’s warranty, there is also a practical reality that different automotive manufacturers and dealers have greatly varying views on aftermarket products, in particular those that produce horsepower, such as performance enhancement chips, modified intake manifolds, or aftermarket exhaust systems. There are dealers and manufacturers out there that will use the presence of a horsepower upgrade to void your vehicle’s warranty. They will do this regardless of whose product you are using. Any aftermarket company that does not acknowledge this is misleading you. The bottom line is that while the law protects the consumer and provides for enforcement of the warranty, it is very difficult for most people to hire an attorney and fight a voided warranty. Edge recommends that you always disconnect and/or remove any performance device or programmer before you take your vehicle to a dealer for any service, in order not to interfere with Diagnostic equipment.
Q: DO I HAVE TO PIERCE THE PUMP WIRE? A: No. By not piercing the pump wire the Comp will automatically be set like an EZ at 65 HP, and 185 ft. lbs. There will not be an additional increase in horsepower until the wire is pierced.
Q: DO I NEED TO UPGRADE MY TRANSMISSION WHEN I ADD THE COMP? A: Upgrading the transmission is not necessary, but it is a great addition, and will help prevent torque converter slippage. It is possible to overdrive the transmission with the comp box, so if you plan on towing heavy loads or driving hard, you should upgrade your transmission
Q: WHAT TYPE OF EGT'S SHOULD I EXPECT TO SEE WHILE RUNNING THE COMP? A: With normal driving your EGT's should remain the same. Under a heavy load in level 3 and above you could see as high as 1350 degrees. Installing a pyrometer gauge is highly recommended to be able to manage your EGT's. For safety, EGT's should remain below 1350 degrees.
Q: WHAT POWER LEVEL IS THE BEST TO TOW WITH? A: Levels 2 and under are the best to tow with. This will help keep your EGT's under control and the power increase, even while towing, is manageable for your transmission.
Q: WHAT TYPE OF BOOST INCREASE SHOULD I EXPECT TO SEE? A: With your waste gate disabled you will see an increase to 26 lbs. in level 1. In level 5 you could see as high as 32 lbs.
Q: HOW MUCH OF AN INCREASE IN GAS MILEAGE SHOULD I EXPECT TO GAIN? A: With normal driving up to a 10% increase in fuel efficiency. Fuel efficiency can vary according to your driving style.
Q: HOW DO I GET THE BEST FUEL MILEAGE? A: Do not change driving habits from normal "good driving mileage" habits. Some find it hard to do with the extra power provided by the Comp.
Q: WHAT DO THE SUB-LEVELS AFFECT? A: The sub-levels affect fueling responsiveness and control the amount of smoke that is created under low boost conditions; this will be especially noticeable if other fueling enhancements have been installed.
Q: DOES THE COMP WORK THE SAME WITH THE ETH MOTOR AS IT DOES WITH THE ETC MOTOR? A: The Comp responds better to the ETC motor than the ETH. With the ETC you will see gains from 40- 120 HP and 350 ft. lbs. of torque. With the ETH you will see gains from 40-95 HP and 280 ft. lbs. of torque.
Please see the installation instructions below for complete details. Please make sure to read the instruction before installing your item. For additional information, please call 1-877-216-5446 or 701-253-5906.
|Edge Comp Dodge Cummins Performance Chip Installation Instructions|
1 Year Warranty
THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK.
Do not use this product until you have carefully read the following agreement.
This sets forth the terms and conditions for the use of this product. The installation of this product indicates that the BUYER has read and understands this agreement and accepts its terms and conditions
DISCLAIMER OF LIABILITY
Edge Products Inc. and its successors, distributors, jobbers, and dealers (hereafter SELLER) shall in no way be responsible for the product's proper use and service. THE BUYER HEREBY WAIVES ALL LIABILITY CLAIMS.
The BUYER acknowledges that he/she is not relying on the SELLER’s skill or judgment to select or furnish goods suitable for any particular purpose and that there are no liabilities which extend beyond the description on the face hereof and the BUYER hereby waives all remedies or liabilities, expressed or implied, arising by law or otherwise, (including without any obligations of the SELLER with respect to fitness, merchantability and consequential damages) or whether or not occasioned by the SELLER's negligence.
The SELLER disclaims any warranty and expressly disclaims any liability for personal injury or damages. The BUYER acknowledges and agrees that the disclaimer of any liability for personal injury is a material term for this agreement and the BUYER agrees to indemnify the SELLER and to hold the SELLER harmless from any claim related to the item of the equipment purchased. Under no circumstances will the SELLER be liable for any damages or expenses by reason of use or sale of any such equipment.
The SELLER assumes no liability regarding the improper installation or misapplication of its products. It is the installer's responsibility to check for proper installation and if in doubt, contact the manufacturer.
LIMITATION OF WARRANTY
Edge Products Inc. (hereafter "SELLER") gives Limited Warranty as to description, quality, merchantability, fitness for any product’s purpose, productiveness, or any other matter of SELLER's product sold herewith. The SELLER shall be in no way responsible for the product’s open use and service and the BUYER hereby waives all rights other than those expressly written herein. This Warranty shall not be extended or varied except by a written instrument signed by SELLER and BUYER.
The Warranty is Limited to one (1) year from the date of sale and limited solely to the parts contained within the product's kit. All products that are in question of Warranty must be returned shipping prepaid to the SELLER and must be accompanied by a dated proof of purchase receipt. All Warranty claims are subject to approval by Edge Products Inc.
If the BUYER sends back a failed unit that is out of warranty and chooses to buy a refurbished unit, the refurbished unit will only carry a 60 day warranty. If the BUYER purchases a new unit at a predetermined discounted rate, it will have the standard 1 year warranty.
Under no circumstances shall the SELLER be liable for any labor charged or travel time incurred in diagnosis for defects, removal, or reinstallation of this product, or any other contingent expenses.
Under no circumstances will the SELLER be liable for any damage or expenses insured by reason of the use or sale of any such equipment.
This warranty is VOID for any new products purchased through auction websites. WARRANTY IS VALID ONLY FOR NEW PRODUCTS PURCHASED THROUGH AUTHORIZED DEALERS (proof of purchase required for all warranty claims).
IN THE EVENT THAT THE BUYER DOES NOT AGREE WITH THIS AGREEMENT: THE BUYER MAY PROMPTLY RETURN THIS PRODUCT, IN A NEW AND UNUSED CONDITION, WITH A DATED PROOF OF PURCHASE, TO THE PLACE OF PURCHASE WITHIN SIXTY (60) DAYS FROM DATE OF PURCHASE FOR A FULL REFUND.
THE INSTALLATION OF THIS PRODUCT INDICATES THAT THE BUYER HAS READ AND UNDERSTANDS THIS AGREEMENT AND ACCEPTS ITS TERMS AND CONDITIONS.