Stampede Tape-On Vent Visors 6064-2
- Vehicle matching style
- Available in a clear or smoke finish
- Quick & easy to mount
- Durably constructed
- Custom molded acrylic
- Made in the USA - Lawrenceville, GA
"Let the fresh air, let the fresh air in" is exactly what you will be singing when you get yourself a set of the Stampede custom window deflectors.
These window visors tape onto the top of your window with high quality 3M automotive tape. With a set of these sidewind deflectors installed you can enjoy opening your window a little, allowing fresh air in without the fear of rain, sleet or snow entering.
These vent visors are custom made to fit each vehicle exactly with a nice, neat contoured look. Stampede offers their vent visors in a smoke finish to further optimize your own personal style. In addition, Stampede window deflectors reduce wind noise and allows stale air to exit while supplying you with a fresh supply.
Constructed from impact resistant acrylic materials the visors are built to last and not fade, scratch or warp, so you can be happy and not worry.
Breathe easier with your own set of Stampede vent visors!
View Available Part Numbers For This Product Line
The Stampede tape on window deflectors offer an easy installation. Simply clean applicable area on your vehicle, peel 3M tape backing off of window deflector and apply to area. For additional information please see the installation guide below or call us at 1-866-309-1907 or 701-253-5906.
|Stampede Vent Visors Installation Instructions|
Limited Lifetime Warranty
Stampede backs their vent visors with a limited lifetime warranty against defects in materials or workmanship.
Product Reviews Summary
|Price / Value||5.0|
|Ease of Installation||1.0|
|1 Customer Review|
Part #: STA-6064-2 Posted on
|I needed to replace just the front passenger door vent but had to buy all 4. Good price on all 4 though, about what I would expect for 1. Problem was that it didn't match the older version exactly. |
The installation instructions were good but difficult to do. I couldn't remove the old glue residue and couldn't find the recommended solvent (3M) in any auto parts store or in Lowe's. I would recommend including it with the vents or suggest that the customer order it when they order the vents.
I tried to make it work anyway and now the ends aren't stuck down completely. Bummer... it's always something.